WM8352
Production Data
REFER TO
REGISTER
ADDRESS
BIT
LABEL
DEFAULT
DESCRIPTION
mask.
2
SPI_4WIRE
0
Selects 3-wire or 4-wire SPI mode
0 = 3-wire mode using bi-directional SDATA pin
1 = 4 wire mode using SDOUT (GPIO6)
Note: SPI_3WIRE must be set for this to take
effect.
Protected by security key. Default held in metal
mask.
1
SPI_3WIRE
0
Selects 2- or 3-/4-wire mode.
0 = 2-wire mode
1 = 3/4 wire mode
Protected by security key. Default held in metal
mask.
Register 06h Interface Control
REGISTER
ADDRESS
BIT
LABEL
DEFAULT
DESCRIPTION
REFER TO
R8 (08h)
Power mgmt
(1)
15:14
CODEC_ISEL[1:0]
10
CODEC Analogue current level select
00 = x 1.5
01 = x 1.0
10 = x 0.75
11 = x 0.5
13
10
VBUF_ENA
0
Forces ON the tie-off amplifiers
0 = disabled
1 = enabled
OUTPUT_DRAIN_ENA
0
Enables a drain on the outputs allowing the
amplifiers to shutdown more quickly.
0 = Shutdown as normal
1 = Sink current from an external capacitor,
allowing faster shutdown.
8
5
MIC_DET_ENA
BIAS_ENA
0
0
Enable MIC detect:
0 = disabled
1 = enabled
Enables bias to analogue audio CODEC
circuitry
0 = disabled
1 = enabled
4
2
MICB_ENA
VMID_ENA
VMID[1:0]
0
0
Microphone bias enable
0 = OFF (high impedance output)
1 = ON
Enables VMID resistor string
0 = disabled
1 = enabled
1:0
00
Resistor selection for VMID potential divider
00 = off
01 = Vmid comes from 300kΩ R-string
10 = Vmid comes from 50kΩ R-string
11 = Vmid comes from 5kΩ R-string
Register 08h Power mgmt (1)
PD, February 2011, Rev 4.4
224
w
WOLFSON [ WOLFSON MICROELECTRONICS PLC ]
