www.ti.com
TMS320F2809, TMS320F2808, TMS320F2806
TMS320F2802, TMS320F2801, UCD9501
TMS320C2802, TMS320C2801, and TMS320F2801x DSPs
SPRS230H – OCTOBER 2003 – REVISED JUNE 2006
Revision History
This data manual was revised from SPRS230G to SPRS230H.
Scope:
Added information/data on TMS320F2801-60, TMS320F2802-60, TMS320F28015, and
TMS320F28016.
•
Information/data on TMS320F2809 is
PRODUCT PREVIEW.
– PRODUCT PREVIEW information concerns products in the formative or design phase of
development. Characteristic data and other specifications are design goals. Texas Instruments
reserves the right to change or discontinue these products without notice.
•
Information/data on TMS320F2802, TMS320F28015, TMS320F28016, TMS320C2802, and
TMS320C2801 is
PRODUCTION DATA.
– PRODUCTION DATA information is current as of publication date. Products conform to
specifications per the terms of Texas Instruments standard warranty. Production processing does
not necessarily include testing of all parameters.
This document has been reviewed for technical accuracy; the technical content is up to date as of the
specified release date with the following changes:
Technical Changes Made for Revision H
Location
Global
Additions, Deletions, Changes
Added information/data on TMS320F28015
Added information/data on TMS320F28016
Added information/data on TMS320C2802-60
Added information/data on TMS320C2801-60
Added 60-MHz devices to first bullet (High-Performance static CMOS Technology) and memory
information on F28015, F28016 to the fourth bullet (On-Chip Memory) in the Features list
Added new devices to the Introduction opening paragraph
Added a new hardware features table for the 60-MHz devices
Corrected pin 48 to GPIO3, not GPIO2 in PZ pinout for the F2808
Added a note to the pinout
Added the F2801x devices to the Flash block on the functional block diagram
Added memory map for F2809 device
Modified PLLCR Register Bit Definitions table and notes under it
Changed TBCNT to TBCTR in ePWM Control and Status Registers table
Modified example of device nomenclature figure to include F2801x devices and -60 for 60-MHz
devices
Changed values for external oscillator/clock source (XCLKIN or X1 pin) With PLL
Added a note under Typical Operational Power Versus Frequency (F2808) figure for F2801x devices
Added clock table and nomenclature table for 60-MHz devices
Added 60-MHz device values to Input Clock Frequency table
Added 60-MHz device values to XCLKIN Timing Requirements - PLL Disabled table
Added 60-MHz device values to XCLKOUT Switching Characteristics (PLL Bypassed or Enabled)
table
Added to note under SPI Master Mode External Timing (Clock Phase = 0) figure
Added to note under SPI Master Mode External Timing (Clock Phase = 1) figure
Deleted note and added Flash to equations following the Flash/OTP Access Timing table. Also
added equation to compute the OTP wait-state.
Added a column for OTP Wait-State, added a row for 60 MHz devices and added the word "Flash"
to the title and two column headers in Minimum Required Flash Wait-States at Different Frequencies
table
Modified section title by adding (C280x only)
Modified ROM/OTP Access Timing table and added ROM to equations below it
Modified title of ROM/ROM (OTP area) Minimum Required Wait-States at Different Frequencies
table by adding ROM/ROM (OTP area)
Revision History
9
TI [ TEXAS INSTRUMENTS ]
