Bits 6 to 3—Address Multiplex (AMX3, AMX2, AMX1, AMX0): Specify address multiplexing
for synchronous DRAM.
For Synchronous DRAM Interface:
Bit6:
Bit5:
Bit 4: Bit 3:
AMX3 AMX2 AMX1 AMX0 Description
1
0
1
1
0
1
0
1
0
0
1
1
0
The row address begins with A10 (The A10 value is output at
A1 when the row address is output. 4M × 16-bit × 4-bank
products)
The row address begins with A11 (The A11 value is output at
A1 when the row address is output. 8M × 16-bit × 4-bank
1
*
products)
The row address begins with A9 (The A9 value is output at A1
when the row address is output. 1M × 16-bit × 4-bank
products)
The row address begins with A10 (The A10 value is output at
A1 when the row address is output. 2M × 8-bit × 4-bank
products, 2M × 16-bit × 4-bank products)
1
0
The row address begins with A9 (The A9 value is output at A1
when the row address is output. 512k × 32-bit × 4-bank
2
*
products)
0
0
Begin synchronous DRAM access after setting AMX3 to 0 =
*1**
(Initial value)
Except above value
Reserved (Setting prohibited)
Notes: 1. Can only be set when using a 16-bit bus width.
2. Can only be set when using a 32-bit bus width.
Bit 2—Refresh Control (RFSH): The RFSH bit determines whether or not synchronous DRAM
refresh operations are is performed. If the refresh function is not used, the timer for generation of
periodic refresh requests can also be used as an interval timer.
Bit 2: RFSH
Description
No refresh
Refresh
0
1
(Initial value)
Rev. 5.00, 09/03, page 247 of 760
RENESAS [ RENESAS TECHNOLOGY CORP ]
