NXP Semiconductors
FXTH87E
FXTH87E, Family of Tire Pressure Monitor Sensors
Bit
7
6
5
4
3
2
1
0
Any Other
Reset
[1]
[1]
[1]
[1]
0
0
0
0
= Reserved
[1] Any of these reset sources that are active at the time of reset will cause the corresponding bit(s) to be set; bits corresponding to sources that are not
active at the time of reset will be cleared.
Table 38.ꢀSRS register field descriptions
Field
Description
Power-On Reset — This bit indicates reset was caused by the power-on detection logic. Because the
internal supply voltage was ramping up at the time, the low-voltage reset (LVR) status bit is also set to
indicate that the reset occurred while the internal supply was below the LVR threshold.
7
POR
0ꢀReset not caused by POR
1ꢀPOR caused reset
External Reset Pin — This bit indicates reset was caused by an active-low level on the external reset pin if
the device was in either the STOP1 or RUN modes. This bit is not set if the external reset pin is pulled low
when the device is in the STOP1 mode.
6
PIN
0ꢀReset not caused by external reset pin
1ꢀReset came from external reset pin
Computer Operating Properly (COP) Watchdog — This bit indicates that reset was caused by the COP
watchdog timer timing out. This reset source may be blocked by COPE = 0.
5
0ꢀReset not caused by COP timeout
1ꢀReset caused by COP timeout
COP
Illegal Opcode — This bit indicates reset was caused by an attempt to execute an unimplemented or illegal
opcode. The STOP instruction is considered illegal if STOP is disabled by STOPE = 0 in the SOPT register.
The BGND instruction is considered illegal if ACTIVE BACKGROUND mode is disabled by ENBDM = 0 in
the BDCSC register.
4
ILOP
0ꢀReset not caused by an illegal opcode
1ꢀReset caused by an illegal opcode
Illegal Address — This bit indicates reset was caused by an attempt to access either data or an instruction
at an unimplemented memory address.
3
0ꢀReset not caused by an illegal address
1ꢀReset caused by an illegal address
ILAD
Programmable Wakeup — This bit indicates reset was caused by a PWU reset in RUN, WAIT, and STOP4.
After STOP1 exit, PRF in PWUCSI indicates PWU was the source of a wakeup.
2
0ꢀReset not caused by PWU.
1ꢀReset caused by PWU.
PWU
Low Voltage Detect — If the LVDRE and LVDSE bits are set and the supply drops below the LVD trip
voltage, an LVD reset will occur. This bit is also set by POR.
1
0ꢀReset not caused by LVD trip or POR.
1ꢀReset caused by LVD trip or POR.
LVD
0
Unused Bit — This bit always reads as a logical zero.
Unused
FXTH87ERM
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2019. All rights reserved.
Reference manual
Rev. 5.0 — 4 February 2019
45 / 183
NXP [ NXP ]
