PIC16F/LF1946/47
7.5.1
INTCON REGISTER
Note:
Interrupt flag bits are set when an interrupt
condition occurs, regardless of the state of
its corresponding enable bit or the Global
Enable bit, GIE, of the INTCON register.
User software should ensure the appropri-
ate interrupt flag bits are clear prior to
enabling an interrupt.
The INTCON register is a readable and writable
register, which contains the various enable and flag bits
for TMR0 register overflow, interrupt-on-change and
external INT pin interrupts.
REGISTER 7-1:
INTCON: INTERRUPT CONTROL REGISTER
R/W-0/0
GIE
R/W-0/0
PEIE
R/W-0/0
TMR0IE
R/W-0/0
INTE
R/W-0/0
IOCIE
R/W-0/0
TMR0IF
R/W-0/0
INTF
R-0/0
IOCIF
bit 7
bit 0
Legend:
R = Readable bit
W = Writable bit
U = Unimplemented bit, read as ‘0’
-n/n = Value at POR and BOR/Value at all other Resets
u = Bit is unchanged
‘1’ = Bit is set
x = Bit is unknown
‘0’ = Bit is cleared
bit 7
GIE: Global Interrupt Enable bit
1= Enables all active interrupts
0= Disables all interrupts
bit 6
bit 5
bit 4
bit 3
bit 2
bit 1
bit 0
PEIE: Peripheral Interrupt Enable bit
1= Enables all active peripheral interrupts
0= Disables all peripheral interrupts
TMR0IE: Timer0 Overflow Interrupt Enable bit
1= Enables the Timer0 interrupt
0= Disables the Timer0 interrupt
INTE: INT External Interrupt Enable bit
1= Enables the INT external interrupt
0= Disables the INT external interrupt
IOCIE: Interrupt-on-Change Enable bit
1= Enables the interrupt-on-change
0= Disables the interrupt-on-change
TMR0IF: Timer0 Overflow Interrupt Flag bit
1= TMR0 register has overflowed
0= TMR0 register did not overflow
INTF: INT External Interrupt Flag bit
1= The INT external interrupt occurred
0= The INT external interrupt did not occur
IOCIF: Interrupt-on-Change Interrupt Flag bit
1= When at least one of the interrupt-on-change pins changed state
0= None of the interrupt-on-change pins have changed state
2010 Microchip Technology Inc.
Preliminary
DS41414A-page 89
MICROCHIP [ MICROCHIP ]
