VTAC HSD USER’S MANUAL: SECTION 3
VIRGINIA PANEL CORPORATION
VTAC HSD RAIL(S) INSTALLATION/REMOVAL INSTRUCTIONS
PART # 310 130 XXX AND 410 130 XXX
TOOLS REQUIRED
Phillips Head Screwdriver
VTAC HSD RAIL(S) REMOVAL INSTRUCTIONS
1. If working with a receiver, use a Phillips head screwdriver to
remove strain relief by removing screws (Figure A).
The ITA will require removal of backshell first. See Section 2 of this
User’s Manual for instructions.
2. After removing strain relief/backshell, use a Phillips head
screwdriver to remove the two Phillips flat head screws that are
holding the frame halves together (Figure A).
PHILLIPS
FLAT HEAD
SCREWS (2)
For ITA use Phillips head screwdriver to loosen the two captive
screws on the back of the rear frame (Figure B).
3. Pull halves apart.
4. Remove VTAC HSD Rail(s).
VTAC HSD RAIL(S) INSTALLATION INSTRUCTIONS
1. To install VTAC HSD Rail(s), orient rail(s) as shown in (Figure A).
Figure C illustrates the identifiers to aid in orientation (receiver rails
shown). The receiver rails are marked with ‘RR’ (receiver right)
and ‘RL’ (receiver left) when viewing from mating face. The ITA
rails are marked with ‘IR’ (ITA right) and ‘IL’ (ITA left) when viewing
from rear/wiring side.
TOP OF
RAIL
2. Place rail(s) ledge on flat surface shown in (Figure D), then put
halves together and tighten the two Phillips flat head screws using
a Phillips head screwdriver.
NOTE: Receiver/ITA frame halves are keyed to be placed together
only one direction.
Figure A. VTAC HSD Rail(s) install/removal (receiver shown).
PHILLIPS
CAPTIVE
SCREWS (2)
BLACK POSITION
AI INDICATOR
‘RL’ RECEIVER
LEFT
‘RR’ RECEIVER
RIGHT
TOP
FLAT SURFACE
BOTTOM
Figure B. ITA frame separation.
Figure C. VTAC HSD Rail(s) - Identifiers. Figure D. VTAC HSD Rail(s) install/removal
(receiver shown).
6/13/16
3-1
For the most current information available, visit www.vpc.com