VTAC HSD USER’S MANUAL: SECTION 2
VIRGINIA PANEL CORPORATION
VTAC HSD INSERT REMOVAL INSTRUCTIONS FOR i2 MX ITA
PART # 410 130 XXX
TOOLS REQUIRED
Phillips Head Screwdriver
Flat Head Screwdriver
1/4” Nut Driver, hollow shaft
VTAC Extraction Tool Kit, Receiver and ITA, Part # 910 112 130
KNOB
REMOVAL INSTRUCTIONS
1. Disengage the ITA from the receiver.
2. Using a flat head screwdriver, remove the engagement
knob screw and engagement knob (Figure A).
3. Using a Phillips head screwdriver, loosen the four screws
(captive) that secure the backshell to the ITA frame
(Figure B).
KNOB SCREW
Figure A. ITA knob removal.
FRAME TO
BACKSHELL
SCREWS
Figure B. Remove frame to backshell screws.
6/13/16
2-6
For the most current information available, visit www.vpc.com