VTAC HSD USER’S MANUAL: SECTION 2
VIRGINIA PANEL CORPORATION
VTAC HSD INSERT INSTALLATION/REMOVAL INSTRUCTIONS FOR ITA MODULE
PART # 510 171 101
TOOLS REQUIRED
VTAC Extraction Tool Kit, Receiver and ITA, Part # 910 112 130
VTAC HSD INSERT INSTALLATION INSTRUCTIONS
BLUE INSERT
1.
Ensure that the VTAC HSD Insert(s) is squared up with the
corresponding module location. Apply gentle pressure and insert
the VTAC HSD Insert(s) into the rear (wiring side) of the module
shown in Figure A. The VTAC HSD Insert(s) can only go into one
side. Once in place, gently pull the wire to ensure the insert(s) is
fully seated.
NOTE: To be fully seated, The insert(s) back shoulder should be flush or
below the module rear face as shown in Section 2-1 Figure C. When
plugging a stack of inserts, the blue insert will always be on top as
shown in Section 2-1 Figure A.
VTAC HSD INSERT REMOVAL INSTRUCTIONS
1. Group the required number of extraction tools together for the
given VTAC HSD patchcord shown in Figure B. The tool pins should
be on opposite sides of the patchcords or wires to be removed.
WARNING: All inserts within each patchcord must be extracted
Figure A. VTAC HSD insert installation.
simultaneously to prevent damage to VTAC HSD Inserts.
NOTE: The extraction tools are magnetic to aid in stacking them
together.
PLUNGER
GRIP
2. While grasping the extraction tool(s) body from the sides, (Figure
B), slide tool pins into module’s extraction cavity slots until the tool
frame is seated against the body shown in Figure C.
WARNING: The extraction tool(s) need to be seated against the
module front face before the plunger is pushed in. Otherwise
damage to insert(s) may occur.
3. Push plunger of extraction tool(s) in to extract VTAC HSD Insert(s).
The insert(s) will be ejected out the wiring side of the module
shown in Figure D.
EXTRACTION TOOL
PINS
DETAIL A
Figure B. Insert removal tool pins.
SEAT
PUSH
PLUNGER
Figure C. Seat removal tool to module frame.
Figure D. Push removal tool plunger.
6/13/16
2-3
For the most current information available, visit www.vpc.com