VTAC HSD USER’S MANUAL: SECTION 2
VIRGINIA PANEL CORPORATION
VTAC HSD INSERT INSTALLATION/REMOVAL INSTRUCTIONS
TOOLS REQUIRED
VTAC Extraction Tool Kit, Receiver and ITA, Part # 910 112 130
VTAC HSD INSERT INSTALLATION INSTRUCTIONS
1.
When inserting a VTAC HSD Insert stack, the blue insert is on top as shown
in Figure B. Inserts are fully seated when the back of the inserts are flush
with the module (Figure A).
VTAC HSD INSERT REMOVAL INSTRUCTIONS
1. Group the required number of extraction tools together for the given VTAC
HSD patchcord. For example, a USB 3.0 patchcord requires two tools as
shown in Figure B.
WARNING: All inserts within each patchcord must be extracted simultaneously
to prevent damage to VTAC HSD Inserts.
NOTE: The extraction tools are magnetic to aid in stacking them together.
2. The indivdual patchcords can be identified by a blue insert, indicating the
beginning of a new stack or single insert patchcord as shown in Figure B.
FLUSH
NOT FLUSH
NOTE: The slots on one side of the module are a slightly
different width than the other side to ensure the insert is
oriented correctly, as shown in Detail C in Figure C.
Figure A. VTAC Insert alignment.
NOTE: For patchcords with more than 3 inserts, multiple VTAC tool kits (910 112
130) will be required.
DETAIL C
C
BLUE INSERT
Y1 LARGE SIDE
Y2 SMALL SIDE
EXAMPLE OF A HDMI PATCHCORD
3 EXTRACTION TOOLS REQUIRED
EXAMPLE OF AN USB PATCHCORD
2 EXTRACTION TOOLS REQUIRED
SINGLE PATCHCORD 1 EXTRACTION
TOOL REQUIRED
EXAMPLE OF A HDMI PATCHCORD
3 EXTRACTION TOOLS REQUIRED
EXTRACTION TOOL CAVITY
WIRING SIDE
MATING FACE
Figure C. VTAC HSD Insert install and removal detail (ITA
Shown).
Figure B. VTAC HSD Insert install and removal detail (ITA Shown).
6/13/16
2-1
For the most current information available, visit www.vpc.com
VPC [ VIRGINIA PANEL CORPORATION ]
