VTAC HSD USER’S MANUAL: SECTION 2
VIRGINIA PANEL CORPORATION
VTAC HSD INSERT REMOVAL INSTRUCTIONS FOR i2 MX ITA
PART # 410 130 XXX
VTAC HSD INSERT REMOVAL INSTRUCTIONS (CONTINUED)
1. Group the required number of extraction tools
together for the given VTAC HSD patchcord shown in
Figure E. The tool pins should be on opposite sides of
the patchcords or wires to be removed.
SEATED
FLUSH
WARNING: All inserts within each patchcord must be
extracted simultaneously to prevent damage to VTAC HSD
Inserts.
GRIP
NOTE: The extraction tools are magnetic to aid in stacking
them together.
2. While grasping the extraction tool(s) body from the
sides (Figure E), slide tool pins into module’s extraction
cavity slots until the tool plunger is flush with the tool
body and the plunger is in contact with the VTAC HSD
insert tips shown in Figure E.
PLUNGER
WARNING: The extraction tool(s) need to be seated against
the module front face before the plunger is pushed in.
Otherwise damage to insert(s) may occur.
3. Push plunger of extraction tool(s) in to extract VTAC
HSD Insert(s). The insert(s) will be ejected out the wiring
side of the module shown in Figure F.
Figure E. Seat removal tool.
PUSH
PLUNGER
Figure F. Insert removal.
6/13/16
2-8
For the most current information available, visit www.vpc.com
VPC [ VIRGINIA PANEL CORPORATION ]
