VTAC HSD USER’S MANUAL: SECTION 2
VIRGINIA PANEL CORPORATION
VTAC HSD INSERT INSTALLATION/REMOVAL INSTRUCTIONS FOR i2 MX ITA
PART # 410 130 XXX
TOOLS REQUIRED
VTAC Extraction Tool Kit, Receiver and ITA, Part # 910 112 130
BLUE INSERT
VTAC HSD INSERT INSTALLATION INSTRUCTIONS
1.
Ensure that the VTAC HSD Insert(s) is squared up with the
corresponding module location. Apply gentle pressure
and insert the VTAC HSD Insert(s) into the rear (wiring
side) of the module shown in Figure A. The VTAC HSD
Insert(s) can only go into one side. Once in place, gently
pull the wire to ensure the insert(s) is fully seated.
NOTE: To be fully seated, The insert(s) back shoulder should
be flush or below the module rear face as shown in Section
2-1 Figure C. When plugging a stack of inserts, the blue insert
will always be on top as shown in Section 2-1 Figure A.
NOTE: Backshell removal instructions start in Section 2-6.
NOTE: For i2 MX ITA Cable Assembly and Backshell Installation
Instructions, refer to the i2 MX User’s manual Section 5.
NOTE: To take advantage of the larger area for bend radius,
it is recommended to plug VTAC patchcords in Tier A as
shown in Section 1-4 Figure B.
Figure A. VTAC HSD Insert installation
6/13/16
2-5
For the most current information available, visit www.vpc.com