4.39 Device Control Register
The device control register is provided for PCI1130 compatibility. It contains bits that are shared between functions
0 and 1. The interrupt mode select is programmed through this register. The socket-capable force bits are also
programmed through this register. See Table 4−17 for a complete description of the register contents.
Bit
7
6
5
4
3
2
1
0
Name
Type
Default
Device control
RW
0
RW
1
RW
1
R
0
RW
0
RW
1
RW
1
RW
0
Register:
Offset:
Type:
Device control
92h (Functions 0, 1)
Read-only, Read/Write
66h
Default:
Table 4−17. Device Control Register Description
BIT
SIGNAL
TYPE
FUNCTION
Socket power lock bit. When this bit is set to 1, software cannot power down the PC Card socket while
in D3. It may be necessary to lock socket power in order to support wake on LAN or RING if the
operating system is programmed to power down a socket when the CardBus controller is placed in the
D3 state.
7 ‡
SKTPWR_LOCK
RW
3-V socket capable force bit.
0 = Not 3-V capable
6 ‡§
3VCAPABLE
RW
1 = 3-V capable (default)
5 ‡
4
IO16R2
RSVD
TEST
RW
R
Diagnostic bit. This bit defaults to 1.
Reserved. This bit returns 0 when read. A write has no effect.
TI test bit. Write only 0 to this bit.
3 ‡§
RW
Interrupt mode. These bits select the interrupt signaling mode. The interrupt mode bits are encoded:
00 = Parallel PCI interrupts only
01 = Reserved
2−1 ‡§
INTMODE
RW
10 = IRQ serialized interrupts and parallel PCI interrupts INTA, INTB, INTC, and INTD
11 = IRQ and PCI serialized interrupts (default)
0 ‡§
RSVD
RW
Reserved. Bit 0 is reserved for test purposes. Only a 0 must be written to this bit.
‡
§
One or more bits in this register are cleared only by the assertion of GRST.
These bits are global in nature and must be accessed only through function 0.
4−28
TI [ TEXAS INSTRUMENTS ]
