DS_1217F_002
73S1217F Data Sheet
Master Clock Control Register (MCLKCtl): 0x8F Å 0x0A
Table 17: The MCLKCtl Register
MSB
LSB
HSOEN KBEN SCEN USBEN 32KEN MCT.2 MCT.1 MCT.0
Bit
Symbol
Function
High-speed oscillator enable. When set = 1, disables the high-speed
crystal oscillator and VCO/PLL system. This bit is not changed when the
PWRDN bit is set but the oscillator/VCO/PLL is disabled. The HSOEN bit
should never be set under normal circumstances. Power down control
should only be initiated via use of the PWRDN bit in MISCtl0.
MCLKCtl.7
HSOEN
1 = Disable the keypad logic clock. This bit is not changed in PWRDN
mode but the function is disabled.
MCLKCtl.6
MCLKCtl.5
MCLKCtl.4
KBEN
SCEN
1 = Disable the smart card logic clock. This bit is not changed in PWRDN
mode but the function is disabled. Interrupt logic for card insertion/removal
remains operable even with smart card clock disabled.
1 = Disable the USB logic clock. This bit is not changed in PWRDN mode
but the function is disabled.
USBEN
1 = Disable the 32Khz oscillator. This function is not affected by PWRDN
mode. Note: This bit must be set if there is no 32KHz crystal. Some
internal clocks and circuits will not run if the oscillator is enabled and
no crystal is connected.
MCLKCtl.3
32KEN
MCLKCtl.2
MCLKCtl.1
MCT.2
MCT.1
This value determines the ratio of the VCO frequency (MCLK) to the high-
speed crystal oscillator frequency such that:
MCLK = (MCount*2 + 4)*Fxtal. The default value is MCount = 2h such that
MCLK = (2*2 + 4)*12.00MHz = 96MHz.
MCLKCtl.0
MCT.0
Rev. 1.2
33
TERIDIAN [ TERIDIAN SEMICONDUCTOR CORPORATION ]
