LPC Interface Bridge Registers (D31:F0)
Table 13-2. DMA Registers (Sheet 2 of 2)
Port
Alias
Register Name
Default
Type
Channel 7 DMA Base & Current Count
Channel 4–7 DMA Command
CEh
CFh
Undefined
Undefined
Undefined
000001XXb
000000XXb
Undefined
Undefined
Undefined
0Fh
R/W
WO
RO
D0h
D1h
Channel 4–7 DMA Status
Channel 4–7 DMA Write Single Mask
Channel 4–7 DMA Channel Mode
Channel 4–7 DMA Clear Byte Pointer
Channel 4–7 DMA Master Clear
Channel 4–7 DMA Clear Mask
Channel 4–7 DMA Write All Mask
D4h
D6h
D8h
DAh
DCh
DEh
D5h
D7h
D9h
DBh
DDh
DFh
WO
WO
WO
WO
WO
R/W
13.2.1
DMABASE_CA—DMA Base and Current Address
Registers (LPC I/F—D31:F0)
I/O Address:
Ch. #0 = 00h; Ch. #1 = 02hAttribute:R/W
Ch. #2 = 04h; Ch. #3 = 06hSize:16 bit (per channel),
Ch. #5 = C4h Ch. #6 = C8h
but accessed in two 8-bit
quantities
Ch. #7 = CCh;
Undefined
No
Default Value:
Lockable:
Power Well:Core
Bit
Description
Base and Current Address — R/W. This register determines the address for the
transfers to be performed. The address specified points to two separate registers. On
writes, the value is stored in the Base Address register and copied to the Current
Address register. On reads, the value is returned from the Current Address register.
The address increments/decrements in the Current Address register after each transfer,
depending on the mode of the transfer. If the channel is in auto-initialize mode, the
Current Address register will be reloaded from the Base Address register after a
terminal count is generated.
15:0
For transfers to/from a 16-bit slave (channels 5–7), the address is shifted left one bit
location. Bit 15 will be shifted into Bit 16.
The register is accessed in 8 bit quantities. The byte is pointed to by the current byte
pointer flip/flop. Before accessing an address register, the byte pointer flip/flop should
be cleared to ensure that the low byte is accessed first.
412
Datasheet
INTEL [ INTEL ]
