Register and Memory Mapping
The scheme is based on the concept that the top block is reserved as the “boot” block,
and the block immediately below the top block is reserved for doing boot-block
updates.
The algorithm is:
1. Software copies the top block to the block immediately below the top
2. Software checks that the copied block is correct. This could be done by performing
a checksum calculation.
3. Software sets the TOP_SWAP bit. This will invert A16 for cycles going to the
Firmware Hub. processor access to FFFF_0000h through FFFF_FFFFh will be
directed to FFFE_0000h through FFFE_FFFFh in the Firmware Hub, and processor
accesses to FFFE_0000h through FFFE_FFFF will be directed to FFFF_0000h
through FFFF_FFFFh.
4. Software erases the top block
5. Software writes the new top block
6. Software checks the new top block
7. Software clears the TOP_SWAP bit
8. Software sets the Top_Swap Lock-Down bit
If a power failure occurs at any point after step 3, the system will be able to boot from
the copy of the boot block that is stored in the block below the top. This is because the
TOP_SWAP bit is backed in the RTC well.
Note:
The top-block swap mode may be forced by an external strapping option (See
Section 2.25.1). When top-block swap mode is forced in this manner, the TOP_SWAP
bit cannot be cleared by software. A re-boot with the strap removed will be required to
exit a forced top-block swap mode.
Note:
Note:
Top-block swap mode only affects accesses to the Firmware Hub space, not feature
space.
The top-block swap mode has no effect on accesses below FFFE_0000h.
§ §
Datasheet
301
INTEL [ INTEL ]
