TLE9879QXA40
Electrical Characteristics
4) Min voltage -2.8V with external 1kΩ series resistor only.
5) To achieve max. ratings on this pin, Parameter P_1.1.44 has to be taken into account resulting in the following dependency:
VGH < VSH + VGHvsSH and additionally VSH < VGH + 0.3V.
6) To achieve max. ratings on this pin, Parameter P_1.1.45 has to be taken into account resulting in the following dependency:
VGL < VSL + VGLvsSL and additionally VSL < VGL + 0.3V.
7) These limits can be kept if max current drawn out of pin does not exceed limit of 200 µA.
8) Includes TMS and RESET.
9) Maximum rating for injection current of GPIO with VIN respected.
10) ESD susceptibility HBM according to ANSI/ESDA/JEDEC JS-001 (1.5kΩ, 100pF)
11) MON with external circuitry of a series resistor of 3.9kΩ and 10nF (at connector); VS with an external ceramic capacitor of
100nF; VSD with an external capacitor of 470nF; VDH with external circuitry of a series resistor of 1kΩ and 3.3nF (at pin).
12) ESD susceptibility, HBM according to ANSI/ESDA/JEDEC JESD22-C101F
Notes
1. Stresses above the ones listed here may cause permanent damage to the device. Exposure to absolute
maximum rating conditions for extended periods may affect device reliability.
2. Integrated protection functions are designed to prevent IC destruction under fault conditions described in the
data sheet. Fault conditions are considered as “outside” normal operating range. Protection functions are not
designed for continuous repetitive operation.
Data Sheet
82
Rev. 1.0, 2015-04-30
INFINEON [ Infineon ]
