Serial Communications Interface Module (SCI)
I/O Registers
13.7.5 SCI Status Register 2
SCI status register 2 (SCS2) contains flags to signal these conditions:
•
•
Break character detected
Incoming data
Address:
$003C
Bit 7
0
6
5
0
4
0
3
0
2
0
1
BKF
R
Bit 0
RPF
R
Read:
Write:
Reset:
0
R
R
R
0
R
0
R
0
R
0
0
0
0
0
R
= Reserved
Figure 13-13. SCI Status Register 2 (SCS2)
BKF — Break Flag
This clearable, read-only bit is set when the SCI detects a break character on
the PTF4/RxD pin. In SCS1, the FE and SCRF bits are also set. In 9-bit
character transmissions, the R8 bit in SCC3 is cleared. BKF does not generate
a CPU interrupt request. Clear BKF by reading SCS2 with BKF set and then
reading the SCDR. Once cleared, BKF can become set again only after logic 1s
again appear on the PTF4/RxD pin followed by another break character. Reset
clears the BKF bit.
1 = Break character detected
0 = No break character detected
RPF —Reception-in-Progress Flag
This read-only bit is set when the receiver detects a logic 0 during the RT1 time
period of the start bit search. RPF does not generate an interrupt request. RPF
is reset after the receiver detects false start bits (usually from noise or a baud
rate mismatch, or when the receiver detects an idle character. Polling RPF
before disabling the SCI module or entering stop mode can show whether a
reception is in progress.
1 = Reception in progress
0 = No reception in progress
MC68HC908MR32 • MC68HC908MR16 — Rev. 6.0
MOTOROLA Serial Communications Interface Module (SCI)
Data Sheet
191
FREESCALE [ Freescale ]
