TABLE IIA. Electrical test requirements. 1/ 2/ 3/ 4/ 5/ 6/ 7/
Line
no.
Test requirements
Subgroups
(in accordance with
MIL-STD-883,
Subgroups
(in accordance with
MIL-PRF-38535, table III)
TM 5005, table I)
Device
class M
Device
class Q
Device
class V
1
2
Interim electrical
parameters (see 4.2)
1, 7, 9
1, 7, 9
Static burn-in I and II
(method 1015)
Not
required
Not
required
Required
3
4
Same as line 1
1*, 7* ∆
Dynamic burn-in
(method 1015)
Required
Required
Required
5
6
Same as line 1
1*, 7* ∆
Final electrical
parameters
1*, 2, 3, 7*, 8A,
8B, 9, 10, 11
1*, 2, 3, 7*, 8A,
8B, 9, 10, 11
1*, 2, 3, 7*, 8A,
8B, 9, 10, 11
7
8
Group A test
requirements
1, 2, 3, 4**, 7,
8A, 8B, 9, 10, 11
1, 2, 3, 4**, 7,
8A, 8B, 9, 10, 11
1, 2, 3, 4**, 7,
8A, 8B, 9, 10, 11
Group C end-point
electrical parameters
2, 3, 7,
8A, 8B
2, 3, 7,
8A, 8B
1, 2, 3, 7, 8A,
8B, 9, 10, 11 ∆
9
Group D end-point
electrical parameters
2, 3, 8A, 8B
1, 7, 9
2, 3, 8A, 8B
1, 7, 9
2, 3, 8A, 8B
1, 7, 9
10
Group E end-point
electrical parameters
(see 4.4)
1/ Blank spaces indicate tests are not applicable.
2/ Any or all subgroups may be combined when using high-speed testers.
3/ Subgroups 7 and 8 functional tests shall verify the functionality for unprogrammed devices or that the altered item
drawing pattern exists for programmed devices.
4/ * indicates PDA applies to subgroup 1 and 7.
5/ ** see 4.4.1c.
6/ ∆ indicates delta limit (see table IIB) shall be required where specified, and the delta values shall be computed
with reference to the previous interim electrical parameters (see line 1).
7/ See 4.4.1d.
SIZE
STANDARD
5962-90965
A
MICROCIRCUIT DRAWING
DEFENSE SUPPLY CENTER COLUMBUS
COLUMBUS, OHIO 43218-3990
REVISION LEVEL
G
SHEET
17
DSCC FORM 2234
APR 97
ACTEL [ Actel Corporation ]
