WM8750JL
Production Data
CONTROL INTERFACE
SELECTION OF CONTROL MODE
The WM8750JL is controlled by writing to registers through a serial control interface. A control word
consists of 16 bits. The first 7 bits (B15 to B9) are address bits that select which control register is
accessed. The remaining 9 bits (B8 to B0) are data bits, corresponding to the 9 bits in each control
register. The control interface can operate as either a 3-wire or 2-wire MPU interface. The MODE pin
selects the interface format.
MODE
Low
INTERFACE FORMAT
2 wire
3 wire
High
Table 41 Control Interface Mode Selection
3-WIRE SERIAL CONTROL MODE
In 3-wire mode, every rising edge of SCLK clocks in one data bit from the SDIN pin. A rising edge on
CSB latches in a complete control word consisting of the last 16 bits.
latch
CSB
SCLK
SDIN
B15
B14
B13
B12
B11
B10
B9
B8
B7
B6
B5
B4
B3
B2
B1
B0
control register address
control register data bits
Figure 25 3-Wire Serial Control Interface
2-WIRE SERIAL CONTROL MODE
The WM8750JL supports software control via a 2-wire serial bus. Many devices can be controlled by
the same bus, and each device has a unique 7-bit address (this is not the same as the 7-bit address
of each register in the WM8750JL).
The WM8750JL operates as a slave device only. The controller indicates the start of data transfer
with a high to low transition on SDIN while SCLK remains high. This indicates that a device address
and data will follow. All devices on the 2-wire bus respond to the start condition and shift in the next
eight bits on SDIN (7-bit address + Read/Write bit, MSB first). If the device address received matches
the address of the WM8750JL and the R/W bit is ‘0’, indicating a write, then the WM8750JL responds
by pulling SDIN low on the next clock pulse (ACK). If the address is not recognised or the R/W bit is
‘1’, the WM8750JL returns to the idle condition and wait for a new start condition and valid address.
Once the WM8750JL has acknowledged a correct address, the controller sends the first byte of
control data (B15 to B8, i.e. the WM8750JL register address plus the first bit of register data). The
WM8750JL then acknowledges the first data byte by pulling SDIN low for one clock pulse. The
controller then sends the second byte of control data (B7 to B0, i.e. the remaining 8 bits of register
data), and the WM8750JL acknowledges again by pulling SDIN low.
The transfer of data is complete when there is a low to high transition on SDIN while SCLK is high.
After receiving a complete address and data sequence the WM8750JL returns to the idle state and
waits for another start condition. If a start or stop condition is detected out of sequence at any point
during data transfer (i.e. SDIN changes while SCLK is high), the device jumps to the idle condition.
DEVICE ADDRESS RD / WR
(7 BITS) BIT
ACK
(LOW)
CONTROL BYTE 1
(BITS 15 TO 8)
ACK
(LOW)
CONTROL BYTE 2
(BITS 7 TO 0)
ACK
(LOW)
SDIN
SCLK
START
STOP
register address and
1st register data bit
remaining 8 bits of
register data
Figure 26 2-Wire Serial Control Interface
PD, April 2012, Rev 4.1
46
w
WOLFSON [ WOLFSON MICROELECTRONICS PLC ]
