欢迎访问ic37.com |
会员登录 免费注册
发布采购

TMS320C6672ACYP25 参数 Datasheet PDF下载

TMS320C6672ACYP25图片预览
型号: TMS320C6672ACYP25
PDF下载: 下载PDF文件 查看货源
内容描述: 多核固定和浮点数字信号处理器 [Multicore Fixed and Floating-Point Digital Signal Processor]
分类和应用: 数字信号处理器
文件页数/大小: 228 页 / 2410 K
品牌: TI [ TEXAS INSTRUMENTS ]
 浏览型号TMS320C6672ACYP25的Datasheet PDF文件第124页浏览型号TMS320C6672ACYP25的Datasheet PDF文件第125页浏览型号TMS320C6672ACYP25的Datasheet PDF文件第126页浏览型号TMS320C6672ACYP25的Datasheet PDF文件第127页浏览型号TMS320C6672ACYP25的Datasheet PDF文件第129页浏览型号TMS320C6672ACYP25的Datasheet PDF文件第130页浏览型号TMS320C6672ACYP25的Datasheet PDF文件第131页浏览型号TMS320C6672ACYP25的Datasheet PDF文件第132页  
TMS320C6672  
Multicore Fixed and Floating-Point Digital Signal Processor  
SPRS708C—February 2012  
www.ti.com  
7.4.3 Soft Reset  
A soft reset will behave like a hard reset except that the PCIe MMRs and DDR3 EMIF MMRs content is retained.  
POR should also remain de-asserted during this time.  
Soft reset is initiated by the following  
RESET pin  
RSCTRL register in PLLCTL  
Watchdog timer  
All the above initiators by default are configured to act as hard reset. Except emulation, all the other 3 initiators can  
be configured as soft resets in the RSCFG register in PLLCTL.  
In the case of a soft reset, the clock logic or the power control logic of the peripherals are not affected, and, therefore,  
the enabled/disabled state of the peripherals is not affected. On a soft reset, the DDR3 memory controller registers  
are not reset. In addition, the DDR3 SDRAM memory content is retained if the user places the DDR3 SDRAM in  
self-refresh mode before invoking the soft reset.  
During a soft reset, the following happens:  
1. The RESETSTAT pin goes low to indicate an internal reset is being generated. The reset is allowed to propagate  
through the system. Internal system clocks are not affected. PLLs also remain locked.  
2. After device initialization is complete, the RESETSTAT pin is deasserted (driven high). In addition, the PLL  
controllers pause their system clocks for about 8 cycles.  
At this point:  
The state of the peripherals before the soft reset is not changed.  
The I/O pins are controlled as dictated by the DEVSTAT register.  
The DDR3 MMRs and PCIe MMRs retain their previous values. Only the DDR3 Memory Controller  
and PCIe state machines are reset by the soft reset.  
The PLL controllers are operating in the mode prior to soft reset. System clocks are unaffected.  
The boot sequence is started after the system clocks are restarted. Since the configuration pins are not latched with  
a System Reset, the previous values, as shown in the DEVSTAT register, are used to select the boot mode.  
128  
Peripheral Information and Electrical Specifications  
Copyright 2012 Texas Instruments Incorporated  
 
 复制成功!