欢迎访问ic37.com |
会员登录 免费注册
发布采购

S29GL128N11TAIV10 参数 Datasheet PDF下载

S29GL128N11TAIV10图片预览
型号: S29GL128N11TAIV10
PDF下载: 下载PDF文件 查看货源
内容描述: 3.0伏只页面模式闪存具有110纳米MirrorBit⑩工艺技术 [3.0 Volt-only Page Mode Flash Memory featuring 110 nm MirrorBit⑩ Process Technology]
分类和应用: 闪存
文件页数/大小: 100 页 / 2678 K
品牌: SPANSION [ SPANSION ]
 浏览型号S29GL128N11TAIV10的Datasheet PDF文件第53页浏览型号S29GL128N11TAIV10的Datasheet PDF文件第54页浏览型号S29GL128N11TAIV10的Datasheet PDF文件第55页浏览型号S29GL128N11TAIV10的Datasheet PDF文件第56页浏览型号S29GL128N11TAIV10的Datasheet PDF文件第58页浏览型号S29GL128N11TAIV10的Datasheet PDF文件第59页浏览型号S29GL128N11TAIV10的Datasheet PDF文件第60页浏览型号S29GL128N11TAIV10的Datasheet PDF文件第61页  
D a t a S h e e t  
START  
Write Program  
Command Sequence  
Data Poll  
from System  
Embedded  
Program  
algorithm  
in progress  
Verify Data?  
Yes  
No  
No  
Increment Address  
Last Address?  
Yes  
Programming  
Completed  
Note: See Table 12 on page 63 and Table 14 on  
page 65 for program command sequence.  
Figure 2. Program Operation  
Program Suspend/Program Resume Command Sequence  
The Program Suspend command allows the system to interrupt a programming operation or  
a Write to Buffer programming operation so that data can be read from any non-suspended  
sector. When the Program Suspend command is written during a programming process, the  
device halts the program operation within 15 µs maximum (5µs typical) and updates the sta-  
tus bits. Addresses are not required when writing the Program Suspend command.  
After the programming operation is suspended, the system can read array data from any  
non-suspended sector. The Program Suspend command may also be issued during a pro-  
gramming operation while an erase is suspended. In this case, data may be read from any  
addresses not in Erase Suspend or Program Suspend. If a read is needed from the Secured  
Silicon Sector area (One-time Program area), then user must use the proper command se-  
quences to enter and exit this region. Note that the Secured Silicon Sector autoselect, and  
CFI functions are unavailable when program operation is in progress.  
The system may also write the autoselect command sequence when the device is in the Pro-  
gram Suspend mode. The system can read as many autoselect codes as required. When the  
device exits the autoselect mode, the device reverts to the Program Suspend mode, and is  
ready for another valid operation. See Autoselect Command Sequence‚ on page 51 for more  
information.  
After the Program Resume command is written, the device reverts to programming. The sys-  
tem can determine the status of the program operation using the DQ7 or DQ6 status bits, just  
S29GL-N_00_B3 October 13, 2006  
S29GL-N MirrorBit™ Flash Family  
55