D a t a S h e e t
Write “Write to Buffer”
command and
Sector Address
Part of “Write to Buffer”
Command Sequence
Write number of addresses
to program minus 1(WC)
and Sector Address
Write first address/data
Yes
WC = 0 ?
No
Write to a different
sector address
Abort Write to
Buffer Operation?
Yes
Write to buffer ABORTED.
Must write “Write-to-buffer
Abort Reset” command
sequence to return
No
(Note 1)
Write next address/data pair
to read mode.
WC = WC - 1
Write program buffer to
flash sector address
Notes:
1. When Sector Address is specified, any address in
the selected sector is acceptable. However, when
loading Write-Buffer address locations with data,
all addresses must fall within the selected
Write-Buffer Page.
2. DQ7 may change simultaneously with DQ5.
Therefore, DQ7 should be verified.
Read DQ15 - DQ0 at
Last Loaded Address
3. If this flowchart location was reached because
DQ5= 1, then the device FAILED. If this
flowchart location was reached because DQ1= 1,
then the Write to Buffer operation was
Yes
DQ7 = Data?
No
ABORTED. In either case, the proper reset
command must be written before the device can
begin another operation. If DQ1=1, write the
Write-Buffer-Programming-Abort-Reset
No
No
command. if DQ5=1, write the Reset command.
DQ1 = 1?
Yes
DQ5 = 1?
Yes
4. See Table 12 on page 63 and Table 14 on
page 65 for command sequences required for
write buffer programming.
Read DQ15 - DQ0 with
address = Last Loaded
Address
Yes
(Note 2)
DQ7 = Data?
No
(Note 3)
FAIL or ABORT
PASS
Figure 1. Write Buffer Programming Operation
54
S29GL-N MirrorBit™ Flash Family
S29GL-N_00_B3 October 13, 2006
SPANSION [ SPANSION ]
