C8051F52x-53x
SFR Definition 11.5. IT01CF: INT0/INT1 Configuration
R/W
IN1PL
Bit7
R/W
IN1SL2
Bit6
R/W
IN1SL1
Bit5
R/W
IN1SL0
Bit4
R/W
IN0PL
Bit3
R/W
IN0SL2
Bit2
R/W
IN0SL1
Bit1
R/W
Reset Value
IN0SL0 00000001
Bit0
SFR Address:
0xE4
Note: Refer to SFR Definition 19.1. “TCON: Timer Control” on page 189 for INT0/1 edge- or level-sensitive interrupt selection.
Bit 7:
IN1PL: /INT1 Polarity
0: /INT1 input is active low.
1: /INT1 input is active high.
Bits 6–4: IN1SL2–0: /INT1 Port Pin Selection Bits
These bits select which Port pin is assigned to /INT1. Note that this pin assignment is inde-
pendent of the Crossbar; /INT1 will monitor the assigned Port pin without disturbing the
peripheral that has been assigned the Port pin via the Crossbar. The Crossbar will not
assign the Port pin to a peripheral if it is configured to skip the selected pin (accomplished by
setting to ‘1’ the corresponding bit in register P0SKIP).
IN1SL2-0
000
/INT1 Port Pin
P0.0
001
P0.1
010
P0.2
011
P0.3
100
P0.4
101
P0.5
110
111
P0.6*
P0.7*
*Note: Available in the C80151F53x parts.
Bit 3:
IN0PL: /INT0 Polarity
0: /INT0 interrupt is active low.
1: /INT0 interrupt is active high.
Bits 2–0: INT0SL2–0: /INT0 Port Pin Selection Bits
These bits select which Port pin is assigned to /INT0. Note that this pin assignment is inde-
pendent of the Crossbar. /INT0 will monitor the assigned Port pin without disturbing the
peripheral that has been assigned the Port pin via the Crossbar. The Crossbar will not
assign the Port pin to a peripheral if it is configured to skip the selected pin (accomplished by
setting to ‘1’ the corresponding bit in register P0SKIP).
IN0SL2-0
000
/INT0 Port Pin
P0.0
001
P0.1
010
P0.2
011
P0.3
100
P0.4
101
P0.5
110
111
P0.6*
P0.7*
*Note: Available in the C80151F53x parts.
98
Rev. 0.3
SILICON [ SILICON ]
