C8051F360/1/2/3/4/5/6/7/8/9
18.5.2. Master Receiver Mode
Serial data is received on SDA while the serial clock is output on SCL. The SMBus interface generates the
START condition and transmits the first byte containing the address of the target slave and the data direc-
tion bit. In this case the data direction bit (R/W) will be logic ‘1’ (READ). Serial data is then received from
the slave on SDA while the SMBus outputs the serial clock. The slave transmits one or more bytes of serial
data. After each byte is received, ACKRQ is set to ‘1’ and an interrupt is generated. Software must write
the ACK bit (SMB0CN.1) to define the outgoing acknowledge value (Note: writing a ‘1’ to the ACK bit gen-
erates an ACK; writing a ‘0’ generates a NACK). Software should write a ‘0’ to the ACK bit after the last
byte is received, to transmit a NACK. The interface exits Master Receiver Mode after the STO bit is set and
a STOP is generated. The interface will switch to Master Transmitter Mode if SMB0DAT is written while an
active Master Receiver. Figure 18.6 shows a typical Master Receiver sequence. Two received data bytes
are shown, though any number of bytes may be received. Notice that the ‘data byte transferred’ interrupts
occur before the ACK cycle in this mode.
S
SLA
R
A
Data Byte
A
Data Byte
N
P
Interrupt
Interrupt
Interrupt
Interrupt
S = START
P = STOP
A = ACK
Received by SMBus
Interface
N = NACK
R = READ
SLA = Slave Address
Transmitted by
SMBus Interface
Figure 18.6. Typical Master Receiver Sequence
214
Rev. 1.0
SILICON [ SILICON ]
