256M GDDR3 SDRAM
K4J55323QG
DLL ENABLE/DISABLE
The DLL must be enabled for normal operation. DLL enable is required during power-up initialization and upon returning to normal oper-
ation after disabling the DLL for debugging or evaluation. (When the device exits self refresh mode, the DLL is enabled automatically.)
Any time the DLL is enabled, 20K clock cycles must occur before an any command can be issued.
DATA TERMINATION
The Data Termination, DT, is used to determine the value of the internal data termination resisters. The GDDR3 SDRAM supports 60Ω
and 120Ω termination. The termination may also be disabled for testing and other purposes.
DATA DRIVER IMPEDANCE
The Data Driver impedance (DZ) is used to determine the value of the data drivers impedance. When auto calibration is used the data
driver impedance is set to RQ/6 and it’s tolerance is determined by the calibration accuracy of the device. When any other value is
selected the target impedance is set nominally to the desired impedance. However, the accuracy is now determined by the device’s spe-
cific process corner, applied voltage and operating temperature.
ADDITIVE LATENCY
The Additive Latency function (AL) is used to optimize the command bus efficiency. The AL value is used to determine the number of
clock cycles that is to be added to CL after CAS is captured by the rising edge of CK. Thus the total CAS latency is determined by add-
ing CL and AL.
15 of 53
Rev. 1.1 November 2005
SAMSUNG [ SAMSUNG ]
