Table 1.4 Pin Functions (cont)
Memory Interface
Pin
No. No. Pin Name I/O
Function
Reset
SRAM DRAM SDRAM PCMCIA MPX
256 M7 NC-13
257 N2
258 P2
NC-14
NC-15
259 P16 NC-16
260 R17 NC-17
261 T4
NC-18
262 T14 NC-19
263 U3
264 U4
NC-20
NC-21
I:
Input
O:
I/O:
Output
Input/output
Power: Power supply
Notes: 1. Except in hardware standby mode, supply power to all power pins. In hardware standby
mode, supply power to RTC as a minimum.
2. Power must be supplied to VDD-PLL1/2 and VSS-PLL1/2 regardless of whether or not
the on-chip PLL circuits are used.
3. Power must be supplied to VDD-CPG and VSS-CPG regardless of whether or not the
on-chip crystal resonator is used.
4. Power must be supplied to VDD-RTC and VSS-RTC regardless of whether or not the
on-chip RTC is used.
5. At least the RTC power supply must be supplied in hardware standby mode.
6. NC pins must be left completely open, and not connected to a power supply, GND, etc.
*
CKIO2 is not connected to PLL2.
Rev. 6.0, 07/02, page 40 of 986
RENESAS [ RENESAS TECHNOLOGY CORP ]
