1. Set the clock selection in SCSCR1.
Be sure to clear bits RIE, TIE, TEIE,
and MPIE, TE and RE, to 0.
Initialization
Clear TE and RE bits
in SCSCR1 to 0
2. Set transmit/receive format in
SCSMR1.
3. Write a value corresponding to the bit
rate into SCBRR1. (Not necessary if
an external clock is used.)
Set RIE, TIE, TEIE, MPIE, CKE1,
and CKE0 bits in SCSCR1
(leaving TE and RE bits
cleared to 0)
4. Wait at least one bit interval, then set
the TE bit or RE bit in SCSCR1 to 1.
Also set the RIE, TIE, TEIE, and MPIE
bits. Setting the TE and RE bits
enables the TxD and RxD pins to be
used.
Set transmit/receive format
in SCSMR1
Set value in SCBRR1
Wait
No
1-bit interval elapsed?
Yes
Set TE and RE bits in SCSCR1
to 1, and set RIE, TIE, TEIE,
and MPIE bits
End
Figure 15.18 Sample SCI Initialization Flowchart
Rev. 6.0, 07/02, page 644 of 986
RENESAS [ RENESAS TECHNOLOGY CORP ]
