to 1. When DMA transfer is used, stop the transfer before setting the MSTP4 bit to 1. When DMA
transfer is performed after clearing the MSTP4 bit to 0, DMAC settings must be made again.
Bit 4: MSTP4
Description
0
1
DMAC operates
(Initial value)
DMAC clock supply is stopped
Bit 3—Module Stop 3 (MSTP3): Specifies stopping of the clock supply to serial communication
interface channel 2 (SCIF) among the on-chip peripheral modules. The clock supply to the SCIF is
stopped when the MSTP3 bit is set to 1.
Bit 3: MSTP3
Description
0
1
SCIF operates
(Initial value)
SCIF clock supply is stopped
Bit 2—Module Stop 2 (MSTP2): Specifies stopping of the clock supply to the timer unit (TMU)
among the on-chip peripheral modules. The clock supply to the TMU is stopped when the MSTP2
bit is set to 1.
Bit 2: MSTP2
Description
0
1
TMU operates
(Initial value)
TMU clock supply is stopped
Bit 1—Module Stop 1 (MSTP1): Specifies stopping of the clock supply to the realtime clock
(RTC) among the on-chip peripheral modules. The clock supply to the RTC is stopped when the
MSTP1 bit is set to 1. When the clock supply is stopped, RTC registers cannot be accessed but the
counters continue to operate.
Bit 1: MSTP1
Description
0
1
RTC operates
(Initial value)
RTC clock supply is stopped
Bit 0—Module Stop 0 (MSTP0): Specifies stopping of the clock supply to serial communication
interface channel 1 (SCI) among the on-chip peripheral modules. The clock supply to the SCI is
stopped when the MSTP0 bit is set to 1.
Bit 0: MSTP0
Description
0
1
SCI operates
(Initial value)
SCI clock supply is stopped
Rev. 6.0, 07/02, page 225 of 986
RENESAS [ RENESAS TECHNOLOGY CORP ]
