RELEASED
PM7380 FREEDM-32P672
DATA SHEET
PMC-1990262
ISSUE 5
FRAME ENGINE AND DATA LINK MANAGER 32P672
Figure 33 – PCI Read Cycle
1
2
3
4
5
6
7
8
9
PCICLK
T
FRAMEB
T
T
T
Address
Data 1
Data 2
Byte Enable
Data 3
AD[31:0]
Bus Cmd
T
C/BEB[3:0]
Byte Enable
Byte Enable
IRDYB
TRDYB
T
T
DEVSELB
A PCI burst write transaction is shown in Figure 34. The cycle is valid for target
and initiator accesses. The target is responsible for incrementing the address for
the duration of the data burst. The 'T' symbol stands for a turn around cycle. A
turn around cycle is required on all signals which can be driven by more than one
agent.
During clock 1, the initiator drives FRAMEB to indicate the start of a cycle. It also
drives the address onto the AD[31:0] bus and drives the C/BEB[3:0] lines with
the write command (in the above example the command would indicate a burst
write). The IRDYB, TRDYB and DEVSELB signals are in turnaround mode (no
agent is driving the signals for this clock cycle). This cycle on the PCI bus is
called the address phase.
During clock 2, the initiator ceases to drive the address onto the AD[31:0] bus
and starts driving the first data word. The initiator also drives the C/BEB[3:0]
lines with the byte enables for the write data. IRDYB is driven active by the
initiator to indicate it is ready to accept the data transfer. The target claims the
transaction by driving DEVSELB active and drives TRDYB to indicate to the
initiator that it is ready to accept the data. All subsequent cycles on the PCI bus
are called data phases.
During clock 3, the target latches in the first data word. The initiator starts to
drive the next data word onto the AD[31:0] lines.
During clock 4, the target latches in the second data word. Both the initiator and
the target indicate that they are not ready to transfer any more data by negating
the ready lines.
PROPRIETARY AND CONFIDENTIAL TO PMC-SIERRA,INC., AND FOR ITS CUSTOMERS’ INTERNAL USE
296
PMC [ PMC-SIERRA, INC ]
