RELEASED
PM7350 S/UNI DUPLEX
DATA SHEET
PMC-1980581
ISSUE 8
DUAL SERIAL LINK PHY MULTIPLEXER
Register 0x5C: Transmit Logical Channel FIFO Control
Bit
Type
Function
Default
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Unused
Unused
Unused
Unused
Unused
Unused
FOVRE
FIFORST
X
X
X
X
X
X
0
R/W
R/W
0
FIFORST:
The FIFORST bit is used to reset all the logical channels of the Transmit
Logical Channel FIFO. When FIFORST is set to logic 0, the FIFO channels
operate normally. When FIFORST is set to logic 1, all the FIFOs are
immediately emptied and ignore writes. The FIFOs remain empty and
continue to ignore writes until logic 0 is written to FIFORST. This results in a
continuous stream of stuff cells on TXD1+/- and TXD2+/-.
If a user cell is currently being sent over the LVDS link it will likely be
corrupted by the reset. If the header portion of the cell has been sent then
this corruption will not be detected at the receiver if header error detection is
enabled. However it will likely be detected if cell error detection is enabled.
See Transmit High-Speed Serial Configuration Register, CELLCRC bit, and
RXD1, RXD2 Serial Configuration Register, CELLCRC bit for details.
FOVRE:
The FOVRE bit enables the generation of an interrupt due to a FIFO overrun
error condition. When FOVRE and the Master Interrupt Enable bit of the
Master Configuration register are set to logic 1, the interrupt is enabled.
PROPRIETARY AND CONFIDENTIAL TO PMC-SIERRA, INC., AND FOR ITS CUSTOMERS’ INTERNAL USE
151
PMC [ PMC-SIERRA, INC ]
