128Mb, 256Mb, 512Mb, 1Gb StrataFlash Memory
SUSPEND and RESUME Operations
Table 24: Valid Commands During Suspend (Continued)
Device Command
Program/Erase Suspend
Program Suspend
Not Allowed
Allowed
Erase Suspend
Not Allowed
Allowed
Program/Erase Resume
RESUME Operation
To resume a suspended ERASE or PROGRAM operation, issue the RESUME command
to any device address. The ERASE or PROGRAM operation continues where it left off,
and the respective status register suspend bit is cleared. Issuing the RESUME command
does not change the read mode.
When the RESUME command is issued during a simultaneous erase suspend or pro-
gram suspend condition, the PROGRAM operation is resumed first. Upon completion of
the PROGRAM operation, the status register should be checked for any errors, and
cleared if needed. The RESUME command must be issued again to complete the ERASE
operation. Upon completion of the ERASE operation, the status register should be
checked for any errors, and cleared if needed.
Table 25: SUSPEND and RESUME Command Bus Cycles
Setup WRITE Cycle
Address Bus
Setup WRITE Cycle
Data Bus
Confirm WRITE Cycle
Address Bus
Confirm WRITE Cycle
Data Bus
Command
SUSPEND
RESUME
Device address
Device address
00B0h
00D0h
–
–
–
–
PDF: 09005aef8448483a
128_256_512_65nm_g18.pdf - Rev. F 8/11 EN
Micron Technology, Inc. reserves the right to change products or specifications without notice.
44
© 2011 Micron Technology, Inc. All rights reserved.