Instructions
N25Q128 - 1.8 V
Figure 55. Bulk Erase instruction sequence DIO-SPI
S
0
1
2
3
C
Instruction
DQ0
DQ1
Dual_Bulk_Erase
9.2.11
Program/Erase Suspend
The Program/Erase Suspend instruction allows the controller to interrupt a Program or an
Erase instruction, in particular: Sector Erase and Dual Command Page Program can be
suspended and erased while Subsector Erase, Bulk Erase, Write Non Volatile Configuration
register, and Program OTP cannot be suspended.
Apart form the parallelizing of the instruction code on the two pins DQ0 and DQ1, the
instruction functionality is exactly the same as the Program/Erase Suspend (PES)
instruction of the Extended SPI protocol.
Figure 56. Program/Erase Suspend instruction sequence DIO-SPI
S
0
1
2
3
4
C
Instruction
DQ0
DQ1
Dual_Program_Erase_Suspend
9.2.12
Program/Erase Resume
After a Program/Erase suspend instruction, a Program/Erase Resume instruction is
required to continue performing the suspended Program or Erase sequence.
Apart form the parallelizing of the instruction code on the two pins DQ0 and DQ1, the
instruction functionality is exactly the same as the Program/Erase Resume (PER)
122/185
MICRON [ MICRON TECHNOLOGY ]
