PIC18F2220/2320/4220/4320
17.3.3
ENABLING SPI I/O
17.3.4
TYPICAL CONNECTION
To enable the serial port, SSP Enable bit, SSPEN
(SSPCON1<5>), must be set. To reset or reconfigure
SPI mode, clear the SSPEN bit, re-initialize the
SSPCON registers and then set the SSPEN bit. This
configures the SDI, SDO, SCK and SS pins as serial
port pins. For the pins to behave as the serial port func-
tion, some must have their data direction bits (in the
TRIS register) appropriately programmed. That is:
Register 17-2 shows a typical connection between two
microcontrollers. The master controller (Processor 1)
initiates the data transfer by sending the SCK signal.
Data is shifted out of both shift registers on their pro-
grammed clock edge and latched on the opposite edge
of the clock. Both processors should be programmed to
the same Clock Polarity (CKP), then both controllers
would send and receive data at the same time.
Whether the data is meaningful (or dummy data)
depends on the application software. This leads to
three scenarios for data transmission:
• SDI must have TRISC<4> bit set
• SDO must have TRISC<5> bit cleared
• SCK (Master mode) must have TRISC<3> bit
cleared
• Master sends data – Slave sends dummy data
• Master sends data – Slave sends data
• SCK (Slave mode) must have TRISC<3> bit set
• SS must have TRISC<5> bit set
• Master sends dummy data – Slave sends data
Any serial port function that is not desired may be over-
ridden by programming the corresponding data
direction (TRIS) register to the opposite value.
FIGURE 17-2:
SPI MASTER/SLAVE CONNECTION
SPI Master SSPM3:SSPM0 = 00xxb
SPI Slave SSPM3:SSPM0 = 010xb
SDO
SDI
Serial Input Buffer
(SSPBUF)
Serial Input Buffer
(SSPBUF)
SDI
SDO
Shift Register
(SSPSR)
Shift Register
(SSPSR)
LSb
MSb
MSb
LSb
Serial Clock
SCK
SCK
PROCESSOR 1
PROCESSOR 2
2003 Microchip Technology Inc.
DS39599C-page 159
MICROCHIP [ MICROCHIP ]
