LT3592
APPLICATIONS INFORMATION
The minimum operating voltage of an LT3592 application
islimitedbytheundervoltagelockout(UVLO, ~3.25V)and
by the maximum duty cycle as outlined above. For proper
startup, the minimum input voltage is also limited by the
boost circuit. If the input voltage is ramped slowly, or the
LT3592 is turned on with its SHDN pin when the output is
already in regulation, then the boost capacitor might not
be fully charged. Because the boost capacitor is charged
with the energy stored in the inductor, the circuit will rely
on some minimum load current to get the boost circuit
running properly. This minimum load generally goes to
zero once the circuit has started. Figure 6 shows a plot
of minimum input voltage needed to start with a 500mA
output current versus output voltage with LED loads. For
LED applications, the output voltage will typically drop
rapidly after start due to diode heating, but this is not
a concern because the voltage to run is lower than the
voltage to start. The plots show the worst case situation
this restricts the input range to one-half of the absolute
maximum rating of the BOOST pin.
Atlightloads,theinductorcurrentbecomesdiscontinuous
and the effective duty cycle can be very high. This reduces
the minimum input voltage to about 400mV above V
.
CAP
At higher load currents, the inductor current is continu-
ous and the duty cycle is limited by the maximum duty
cycle of the LT3592, requiring a higher input voltage to
maintain regulation.
Soft-Start
TheSHDNpincanbeusedtosoft-starttheLT3592,reducing
the maximum input current during startup. The SHDN pin
is driven through an external RC filter to create a voltage
ramp at this pin. Figure 7 shows the startup waveforms
with and without the soft-start circuit. By choosing a large
RC time constant, the peak startup current can be reduced
to programmed LED current, with no overshoot. Choose
the value of the resistor so that it can supply 20μA when
the SHDN pin reaches 2.3V.
when V is ramping very slowly. For a lower startup
IN
voltage, the boost diode’s anode can be tied to V , but
IN
12
11
10
9
12
11
10
9
12
11
10
9
8
8
8
7
7
7
6
6
6
5
5
5
4
4
4
3
3
3
2
2
2
2
4
6
8
10
12
2
4
6
8
10
12
2
4
6
8
10
INPUT VOLTAGE (V)
2.2MHz, L = 4.7μH
12
14
16
INPUT VOLTAGE (V)
INPUT VOLTAGE (V)
3592 F06c
400kHz, L = 22μH
900kHz, L = 6.8μH
3592 F06b
3592 F06a
Figure 6. Input Voltage Needed to Start at 500mA Output Current vs LED Voltage
3592fc
15
Linear Systems [ Linear Systems ]
