A10-DATASHEET
2015.12.31
107
Document Revision History
Date
Version
Changes
•
Made the following changes to the "Transmitter Specifications" table:
•
•
•
Added the VOCM (AC coupled) parameter.
Added the VOCM (DC coupled) parameter.
Changed the rise and fall time mimimum and maximum specifications.
•
•
Added the "Typical Transmitter VOD Settings" table.
Added a note to VCC, VCCP, and VCCERAM typical values in Recommended Operating Conditions table.
Note: You can operate –1 and –2 speed grade devices at 0.9 V or 0.95 V typical value. You can operate -3
speed grade device at only 0.9 V typical value. Core performance shown in this datasheet is applicable for the
operation at 0.9 V. Operating at 0.95 V results in higher core performance and higher power consumption.
For more information about the performance and power consumption of 0.95 V operation, refer to the
Quartus Prime software timing reports and Early Power Estimator (EPE).
•
•
Removed military grade operating junction temperature specifications (TJ) in Recommended Operating
Conditions table.
Updated the VCCIO range for HSTL-18 I/O standard in Differential HSTL and HSUL I/O Standards for
Arria 10 Devices table as follows:
•
•
•
Min: Updated from 1.425 V to 1.71 V
Typ: Updated from 1.5 V to 1.8 V
Max: Updated from 1.575 V to 1.89 V
•
•
•
Added a statement to Differential I/O Standards Specifications for Arria 10 Devices table: Differential inputs
are powered by VCCPT which requires 1.8 V.
Added statement in I/O Standard Specifications: You must perform timing closure analysis to determine the
maximum achievable frequency for general purpose I/O standards.
Updated fractional PLL specifications.
•
•
•
Updated fOUT_C to fOUT and updated the maximum value to 644 MHz for all speed grades.
Updated fVCO minimum value from 2.4 GHz to 3.125 GHz.
Removed fOUT_L, kVALUE, and fRES parameters.
Arria 10 Device Datasheet
Send Feedback
Altera Corporation
INTEL [ INTEL ]
