S12S Debug Module (S12SDBGV2)
6.3.2.7.3
Debug State Control Register 3 (DBGSCR3)
Address: 0x0027
7
6
5
4
3
2
1
0
R
W
0
0
0
0
0
SC3
SC2
SC1
SC0
Reset
0
0
0
0
0
0
0
= Unimplemented or Reserved
Figure 6-11. Debug State Control Register 3 (DBGSCR3)
Read: If COMRV[1:0] = 10
Write: If COMRV[1:0] = 10 and DBG is not armed.
This register is visible at 0x0027 only with COMRV[1:0] = 10. The state control register three selects the
targeted next state whilst in State3. The matches refer to the match channels of the comparator match
control logic as depicted in Figure 6-1 and described in 6.3.2.8.1. Comparators must be enabled by setting
the comparator enable bit in the associated DBGXCTL control register.
Table 6-19. DBGSCR3 Field Descriptions
Field
Description
3–0
These bits select the targeted next state whilst in State3, based upon the match event.
SC[3:0]
Table 6-20. State3 — Sequencer Next State Selection
SC[3:0]
0000
0001
0010
0011
0100
0101
0110
0111
1000
1001
1010
1011
1100
1101
1110
1111
Description (Unspecified matches have no effect)
Match0 to State1
Match2 to State2........ Match1 to Final State
Match0 to Final State....... Match1 to State1
Match1 to Final State....... Match2 to State1
Match1 to State2
Match1 to Final State
Match2 to State2........ Match0 to Final State
Match0 to Final State
Reserved
Reserved
Either Match1 or Match2 to State1....... Match0 to Final State
Reserved
Reserved
Either Match1 or Match2 to Final State....... Match0 to State1
Match0 to State2....... Match2 to Final State
Reserved
The priorities described in Table 6-36 dictate that in the case of simultaneous matches, a match leading to
final state has priority followed by the match on the lower channel number (0,1,2).
S12P-Family Reference Manual, Rev. 1.13
Freescale Semiconductor
167
FREESCALE [ Freescale ]
