FUNCTIONAL DEVICE OPERATION
OPERATIONAL MODES
normal 33742 operation, it is recommended that the disable
be done using the following sequence:
DEBUG MODE: HARDWARE AND SOFTWARE
DEBUG WITH THE 33742
• Step 1–Power down the SBC.
When a SBC, and the MCU it serves, is used on the same
printed circuit board, both the MCU software and the 33742
operation must be debugged concurrently. The following
features permit system debugging by allowing the disabling
of the SBC internal software watchdog timer.
• Step 2–Power up the SBC. This sets the BATFAIL bit,
allowing the 33742 to enter Normal Request mode.
• Step 3–Write to the TIM1 sub register to allow the SBC to
enter Normal mode.
• Step 4–Write to the MCR register with data 0000. This
enables the debug mode. Complete SPI byte is
0001 0000.
DEVICE POWER-UP, RESET PIN CONNECTED TO
VDD
• Step 5–Write to the MCR register normal debug. SPI byte
is 0001 x101.
The VDD voltage is available when the 33742 power-up
but the 33742 will not have received any SPI communication
to configure itself. Until set up by the system MCU, the 33742
will generate a reset every 350 ms until the part is configured.
To avoid continuous MCU hardware resets, the 33742’s RST
pin can be connected directly to VDD pin by a hardware
jumper.
Important While in debug mode, the SBC can be used
without having to clear the watchdog on a regular basis to
facilitate software and hardware debug.
• Step 6–To leave the debug mode, write 0000 to the MCR
register.
At Step 2, the SBC is in Normal Request. Steps 3, 4, and 5
should be completed consecutively and within the 350 ms
time period of the Normal Request mode. If not, the 33742
will go into Reset mode and enter Normal Request again.
DEBUG MODES WITH SOFTWARE WATCHDOG
DISABLED THOUGH SPI (NORMAL DEBUG,
STANDBY DEBUG, AND STOP DEBUG)
The software configurable watchdog can be disabled
through SPI. To set the watchdog disable while limiting the
risk of inadvertently disabling the watchdog timer during
Figure 15, page 30, illustrates debug mode selection.
VSUP
VDD
BATFAIL
TIM1(Step 3)
MCR (Step 5)
SPI: Read BATFAIL
MCR (Step 6)
SPI
MCR (Step 4)
33742 not in Debug mode.
Watchdog ON
Debug Mode
33742 in Debug mode.
No Watchdog
Figure 15. Entering Debug Mode
When the SBC is operating in the debug mode and has
been set into Stop Debug or Sleep mode, a wake-up causes
the 33742 to enter the Normal Request mode for 350 ms. To
avoid having the SBC generate an unwanted reset (enter
Reset mode), the next debug mode (Normal Debug or
Standby Debug) should be configured within the 350 ms time
window of the Normal Request mode.
To avoid entering debug mode after a power-up, first read
the BATFAIL bit (MCR read) and write 0000 into the MCR
register.
Figures 16 and 17, page 31, show the detailed operation
of the SBC once the debug mode has been selected.
33742
Analog Integrated Circuit Device Data
Freescale Semiconductor
30
FREESCALE [ Freescale ]
