EM78P259N/260N
8-Bit Microprocessor with OTP ROM
Bit 2 (CMPWE): Comparator wake-up enable bit
0 = Disable Comparator wake-up
1 = Enable Comparator wake-up
When Comparator enters sleep mode, this bit must be set to “Enable.“
Bit 1 (ICWE): Port 5 input change to wake-up status enable bit
0 = Disable Port 5 input change to wake-up status
1 = Enable Port 5 input change to wake-up status
When Port 5 change enters sleep mode, this bit must be set to
“Enable.“
Bit 0:
Not implemented, read as ‘0’
6.1.15 RF (Interrupt Status 2 Register)
7
6
5
4
3
2
1
0
LPWTIF
HPWTIF
TCCCIF
TCCBIF
TCCAIF
EXIF
ICIF
TCIF
NOTE
■ “1” means interrupt request; “0” means no interrupt occurs.
■ RF can be cleared by instruction but cannot be set.
■ IOCF0 is the relative interrupt mask register.
■ Reading RF will result to "logic AND" of RF and IOCF0.
Bit 7 (LPWTIF): Internal low-pulse width timer underflow interrupt flag for IR/PWM
function. Reset by software.
Bit 6 (HPWTIF): Internal high-pulse width timer underflow interrupt flag for IR/PWM
function. Reset by software.
Bit 5 (TCCCIF): TCCC overflow interrupt flag. Set when TCCC overflows. Reset by
software.
Bit 4 (TCCBIF): TCCB overflow interrupt flag. Set when TCCC overflows. Reset by
software.
Bit 3 (TCCAIF): TCCA overflow interrupt flag. Set when TCCC overflows. Reset by
software.
Bit 2 (EXIF):
Bit 1 (ICIF):
Bit 0 (TCIF):
External interrupt flag. Set by falling edge on /INT pin. Reset by
software.
Port 5 input status change interrupt flag. Set when Port 5 input
changes. Reset by software.
TCC overflow interrupt flag. Set when TCC overflows. Reset by
software.
6.1.16 R10 ~ R3F
All of these are 8-bit general-purpose registers.
Product Specification (V1.0) 06.16.2005
• 15
(This specification is subject to change without further notice)
ELAN [ ELAN MICROELECTRONICS CORP ]
