BNCꢀSeries
Unit：mm
○Assembly Instruction（2）
Parts Configulration
Boot
Ferule
Center Conductor
Body
Insert the boot, ferule into the cable and cut the
①
①
ꢀꢀcable as fig.1.
15mm
●ꢀPlease be careful to not damage the outer
ꢀꢀconductor.
Cut the insulator and outer conductor as fig.2.
②
②
ꢀꢀPre-solder the center conductor and cut as fig.2.
●ꢀWhen cutting the insulator, please be careful to not
ꢀꢀdamage the center conductor.
13.3mm
10.6mm
6.6mm
Solder up the contact to the center conductor.
③
ꢀ Spread the end of the outer conductor to insert the
body between insulator and outer conductor easily.
ꢀ Please do not pick the outer conductor.
● Please be caredule to not be swelled up the solder.
Shave the excessed solder along the outside of the
contact.
③
④
● Please be careful to not deform the insulator by
soldering.
Insert the body into the cable between insulator and
outer conductor until the top of the contact is on the
same plane with the top of the body and move the
④
A
ferule to the body. Crimp the ferule at position
Edge of Crimp Dies
Edge of Body
B
and position
.
0.5～1.0mm
A
B
⑤
.
⑤ Cover the boot on the ferule
Boot
◎ Please acknowledge that the specification etc. of this catalog might change by the improvement etc. without notice.
ꢀMoreover, the characteristic and the specification of the published product are the reference values.
ꢀPlease confirm the content with the latest delivery specifications when you use the product.
http://www.ddknet.co.jp
10
DDK [ DDK LTD. ]
