BNCꢀSeries
Unit：mm
○ Assembly Instruction（4）
Parts Configulration
Insulator
Bayonet
Delta-mate Outer Conductor
Body
Crimp
Crimp area
*Insulator
Ferule
Sleeve
Contact
(24.3)
BNC-P mating side
*The insulator is attached with BNC-P-1.5D-CR10-CF.
Please cover the sheath when crimping the contact.
①
(24.3)
(24.3)
Cut the cable as fig.1.
①
ꢀꢀL Amm=Lmm-12mm
L
Cable
Remove the sheath
②
●ꢀPlease be careful to not damage the outer
ꢀꢀconductor.
LA
②
③
15
Insert the ferule and spread the tip of the outer
③
ꢀconductor.
Plunge the sleeve by stripper without
Assembly Tool
Attachment
89134
ꢀdiging the edge.
CR-H-1115
CR-H-1116
CR-H-1120A
89141
Sleeve
Ferule
Cut the center conductor by stripper as fig.4.
④
⑤
Cut the insulator by stripper as fig.5.
Insert the stripper and dig the edge to the
insulator. Rotate the stripper a few times and pull
B
⑤
B
C
④
⑥
Stripper
ꢀ off the insulator.
A
D
Trim the extra outer conductor along the sleeve.
⑥
⑦
Put the contact into the crimp tool attachment and
insert it into the crimp dies as fig.7. Insert the
center conductor into the contact hole and crimp
the contact with touching the contact brim to the
end of sheath.
⑦
⑧
⑨
Insert the above contact assembly into the body
until the top of contact is same plane as rim
of outer conductor.
⑧
● After the contact brim is inserted into the body,
do not rotate the cable and body.
⑨
Put the above cable assembly in the crimp tool and
crimp the root of the body.
⑨
● Please match the hex of dies with the hole of the
body.
for CR-H-1120A
◎ Please acknowledge that the specification etc. of this catalog might change by the improvement etc. without notice.
ꢀMoreover, the characteristic and the specification of the published product are the reference values.
ꢀPlease confirm the content with the latest delivery specifications when you use the product.
http://www.ddknet.co.jp
12
DDK [ DDK LTD. ]
