ATmega8U2/16U2/32U2
21.18.13 UESTA0X – USB Endpoint Status 0 Register
Bit
7
6
OVERFI
R/W
0
5
UNDERFI
R/W
4
-
3
2
1
0
(0xEE)
CFGOK
DTSEQ1:0
NBUSYBK1:0
UESTA0X
Read/Write
Initial Value
R
0
R
0
R
0
R
0
R
0
R
0
0
• Bit 7 – CFGOK: Configuration Status Flag
This flag bit is set by hardware when the selected endpoint size parameter (EPSIZE) and num-
ber of banks (EPBK) are correct compared to the max FIFO capacity. This bit is updated when
the bit ALLOC is set, if the USB controller can not allocate the correct amount of memory for the
selected endpoint, this flag bit will be cleared.
If this bit is cleared, the user should reprogram the UECFG1X register with correct EPSIZE and
EPBK values.
• Bit 6 – OVERFI: Overflow Error Interrupt Flag
This flag is set when an overflow error occurs for an isochronous endpoint.This OVERFI flag can
generate a “USB endpoint interrupt” if FLERRE bit is set. Writing this bit to zero acknowledges
the interrupt source (USB clocks must be enabled before). Writing this bit to one has no effect.
See “Isochronous mode” on page 207 for more details.
• Bit 5 – UNDERFI: Underflow Error Interrupt Flag
This flag is set when an underflow error occurs for an isochronous endpoint.This UNDERFI flag
can generate a “USB endpoint interrupt” if FLERRE bit is set. Writing this bit to zero acknowl-
edges the interrupt source (USB clocks must be enabled before). Writing this bit to one has no
effect.
See “Isochronous mode” on page 207 for more details.
• Bit 4 – Res: Reserved
This bit is reserved and will always read as zero.
• Bit 3:2 – DTSEQ[1:0]: Data Toggle Sequencing Flag
These flags are set by hardware to indicate the PID data of the current bank as shown in Table
21-5.
For OUT transfer, this value indicates the last data toggle received on the current bank. For IN
transfer, it indicates the Toggle that will be used for the next packet to be sent. This is not rela-
tive to the current bank.
Table 21-5.
DTSEQ[1:0] Bits Settings
DTSEQ1
DTSEQ1
PID DATA
DATA0
0
0
1
1
0
1
0
1
DATA1
Reserved.
217
7799D–AVR–11/10
ATMEL [ ATMEL ]
