A67P16181/A67P06361 Series
Absolute Maximum Ratings*
*Comments
Power Supply Voltage (VCC) . . . . . . . . . . -0.3V to +3.6V
Voltage Relative to GND for any Pin Except VCC (Vin,
Vout) . . . . . . . . . . . . . . . . . . . . . . . -0.3V to VCC +0.3V
Operating Temperature (Topr) . . . . . . . . . . . 0°C to 70°C
Storage Temperature (Tbias) . . . . . . . . . . -10°C to 85 °C
Storage Temperature (Tstg) . . . . . . . . . . -55°C to 125°C
Stresses above those listed under "Absolute Maximum
Ratings" may cause permanent damage to this device.
These are stress ratings only. Functional operation of
this device at these or any other conditions above those
indicated in the operational sections of this specification
is not implied or intended. Exposure to the absolute
maximum rating conditions for extended periods may
affect device reliability.
DC Electrical Characteristics and Operating Conditions
(0°C ≤ TA ≤ 70°C, VCC, VCCQ = +2.5V± 5% unless otherwise noted)
Symbol
VIH
Parameter
Input High Voltage
Conditions
Min.
1.7
Max.
VCC+0.3
0.7
Unit
V
Note
1,2
VIL
Input Low Voltage
-0.3
-2.0
-2.0
V
1,2
ILI
Input Leakage Current
Output Leakage Current
0V ≤ VIH ≤ VCC
2.0
µA
µA
ILO
Output(s) disabled,
2.0
0V ≤ VIN≤ VCC
VOH
VOL
Output High Voltage
Output Low Voltage
Supply Voltage
IOH = -1.0mA
IOL = 1.0mA
2.0
V
V
V
V
1,3
1,3
1
0.4
VCC
VCCQ
2.375
2.375
2.625
VCC
Isolated Output Buffer Supply
1,4
Capacitance
Symbol
CI
Parameter
Conditions
TA = 25°C; f = 1MHz
VCC = 2.5V
Typ.
Max.
4
Unit
pF
Note
Control Input Capacitance
Input/Output Capacitance (I/O)
Address Capacitance
3
4
3
6
6
6
CO
5
pF
CA
3.5
pF
Note : 1. All voltages referenced to VSS (GND).
2. Overshoot : VIH ≤ +3.6V for t ≤ tKHKH/2 for I ≤ 20mA
Undershoot : VIL ≥ -0.7V for t ≤ tKHKH/2 for I ≤ 20mA
Power-up : VIH ≤ +2.625V and VCC ≤ 2.375V for t ≤ 200ms
3. The load used for VOH, VOL testing is shown in Figure 2. AC load current is higher than the shown DC values.
AC I/O curves are available upon request.
4. VCC and VCCQ can be externally wired together to the same power supply.
5. This parameter is sampled.
PRELIMINARY (August, 2004, Version 0.1)
10
AMIC Technology, Corp.
AMICC [ AMIC TECHNOLOGY ]
