8
MREINTE PHY Management Read Error In-
terrupt Enable. If MREINTE is
set, the MREINT bit will be able to
set the INTR bit.
When MCCINT is set to 1, INTA
is asserted if the enable bit MC-
CINTE is set to 1.
This bit is always read/write ac-
cessible. MCCINT is cleared by
the host by writing a 1. Writing a
0 has no effect. MCCINT is
cleared by H_RESET and is not
affected by S_RESET or setting
the STOP bit.
This bit is always read/write ac-
cessible. MREINTE is set to 0 by
H_RESET and is not affected by
S_RESET or setting the STOP bit
7
MAPINT
PHY Management Auto-Poll In-
terrupt. The PHY Auto-Poll inter-
rupt is set by the Am79C978
controller to indicate that the cur-
rently read status does not match
the stored previous status indi-
cating a change in state for the in-
ternal PHY. A change in the Auto-
Poll Access Method (BCR32, Bit
11) will reset the shadow register
and will not cause an interrupt on
the first access from the Auto-Poll
section. Subsequent accesses
will generate an interrupt if the
shadow register and the read
register produce differences.
4
MCCINTE PHY Management Command
Complete Interrupt Enable. If
MCCINTE is set to 1, the MC-
CINT bit will be able to set the
INTR bit when the host reads or
writes to the internal PHY Data
Port (BCR34) only. Internal PHY
Management Commands will not
generate an interrupt. For in-
stance Auto-Poll state machine
generated management frames
will not generate an interrupt
upon completion unless there is a
compare error which gets report-
ed through the MAPINT (CSR7,
bit 6) interrupt or the MCCIINTE
is set to 1.
When MAPINT is set to 1, INTA is
asserted if the enable bit MAP-
INTE is set to 1.
This bit is always read/write ac-
cessible. MCCINTE is set to 0 by
H_RESET and is not affected by
S_RESET or setting the STOP
bit.
This bit is always read/write ac-
cessible. MAPINT is cleared by
the host by writing a 1. Writing a
0 has no effect. MAPINT is
cleared by H_RESET and is not
affected by S_RESET or setting
the STOP bit.
3
MCCIINT
PHY Management Command
Complete Internal Interrupt. The
PHY Management Command
Complete Interrupt is set by the
Am79C978 controller when a
read or write operation on the in-
ternal PHY management port is
complete from an internal opera-
tion. Examples of internal opera-
tions are Auto-Poll or PHY
Management Port generated
management frames. These are
normally hidden to the host.
6
MAPINTE PHY Auto-Poll Interrupt Enable.
If MAPINTE is set, the MAPINT
bit will be able to set the INTR bit.
This bit is always read/write ac-
cessible. MAPINTE is set to 0 by
H_RESET and is not affected by
S_RESET or setting the STOP
bit.
5
MCCINT
PHY Management Command
Complete Interrupt. The PHY
Management Command Com-
plete Interrupt is set by the
Am79C978 controller when a
read or write operation to the in-
ternal PHY Data Port (BCR34) is
complete.
When MCCIINT is set to 1, INTA
is asserted if the enable bit MC-
CINTE is set to 1.
This bit is always read/write ac-
cessible. MCCIINT is cleared by
the host by writing a 1. Writing a
0 has no effect. MCCIINT is
cleared by H_RESET and is not
124
Am79C978
AMD [ AMD ]
