RTL8201BL
5.6 LED Interface/PHY Address Config
These five pins are latched into the RTL8201BL during power up reset to configure PHY address [0:4] used for MII
management register interface. And then, in normal operation after initial reset, they are used as driving pins for status
indication LED. The driving polarity, active low or active high, is determined by each latched status of the PHY address [4:0]
during power-up reset. If latched status is High then it will be active low, and if latched status is Low then it will be active high.
Refer to Section 7.5 for more information.
Symbol
PHYAD0/
LED0
Type
LI/O
Pin No.
Description
9
PHY Address [0]
Link LED: Active when linked.
PAD1/
LI/O
LI/O
10
12
PHY Address [1]
LED1
PHYAD2/
LED2
Full Duplex LED: Active when in Full Duplex operation.
PHY Address [2]
Link 10/ACT LED: Active when linked in 10Base-T mode, and blinking
when transmitting or receiving data.
PHYAD3/
LED3
LI/O
LI/O
13
15
PHY Address [3]
Link 100/ACT LED: Active when linked in 100Base-TX and blinking
when transmitting or receiving data.
PHYAD4/
LED4
PHY Address [4]
Collision LED: Active when collisions occur.
5.7 Reset and other pins
Symbol
Type
Pin No.
Description
RESETB
I
42
RESETB: Set low to reset the chip. For a complete reset function, this pin
must be asserted low for at least 10ms.
PWFBOUT
O
I
32
Power Feedback Output: Be sure to connect a 22uF tantalum capacitor for
frequency compensation and a 0.1uF capacitor for noise de-coupling. Then
connect this pin through a ferrite bead to PWFBIN(pin8). The connection
method is figured in section 7.11.
Power Feedback Input: see the description of PWFBOUT.
Not connection
PWFBIN
NC
8
27
5.8 Power and Ground pins
Symbol
AVDD33
Type
P
Pin No.
Description
3.3V Analog power input: 3.3V power supply for analog circuit; should be
well decoupled.
Analog Ground: Should be connected to a larger GND plane
3.3V Digital Power input: 3.3V power supply for digital circuit.
Digital Ground: Should be connected to a larger GND plane.
36
AGND
DVDD33
DGND
P
P
P
29,35
14,48
11,17,45
2002-03-29
Rev.1.2
7
ETC [ ETC ]
