Z8 Encore! XP® 4K Series
Product Specification
174
•
Read OCD Revision (00H)—The Read OCD Revision command determines the ver-
sion of the On-Chip Debugger. If OCD commands are added, removed, or changed, this
revision number changes.
DBG ← 00H
DBG → OCDRev[15:8] (Major revision number)
DBG → OCDRev[7:0] (Minor revision number)
•
•
Read OCD Status Register (02H)—The Read OCD Status Register command reads the
OCDSTAT register.
DBG ← 02H
DBG → OCDSTAT[7:0]
Read Runtime Counter (03H)—The Runtime Counter counts system clock cycles in
between Breakpoints. The 16-bit Runtime Counter counts up from 0000Hand stops at the
maximum count of FFFFH. The Runtime Counter is overwritten during the Write Memo-
ry, Read Memory, Write Register, Read Register, Read Memory CRC, Step Instruction,
Stuff Instruction, and Execute Instruction commands.
DBG ← 03H
DBG → RuntimeCounter[15:8]
DBG → RuntimeCounter[7:0]
•
Write OCD Control Register (04H)—The Write OCD Control Register command
writes the data that follows to the OCDCTL register. When the Flash Read Protect Option
Bit is enabled, the DBGMODE bit (OCDCTL[7]) can only be set to 1, it cannot be cleared
to 0 and the only method of returning the device to normal operating mode is to reset the
device.
DBG ← 04H
DBG ← OCDCTL[7:0]
•
•
Read OCD Control Register (05H)—The Read OCD Control Register command reads
the value of the OCDCTL register.
DBG ← 05H
DBG → OCDCTL[7:0]
Write Program Counter (06H)—The Write Program Counter command writes the data
that follows to the eZ8 CPU’s Program Counter (PC). If the device is not in DEBUG mode
or if the Flash Read Protect Option bit is enabled, the Program Counter (PC) values are
discarded.
DBG ← 06H
DBG ← ProgramCounter[15:8]
DBG ← ProgramCounter[7:0]
PS022815-0206
On-Chip Debugger
ZILOG [ ZILOG, INC. ]
