Z8018x Family
MPU User Manual
109
memory mapped I/O. transfers, the CKA0/DREQ0 pin automatically
functions as input pin or output pin even if it has been programmed as
output pin for CKA0. And the CKA1/TEND0 pin functions as an input or
an output pin for TEND0 by setting CKA1D to 1 in CNTLA1.
To initiate memory to/from I/O (and memory to/from memory mapped
I/O) DMA transfer for channel 0, perform the following operations:
1. Load the memory and I/O or memory mapped I/O source and
destination addresses into SAR0 and DAR0.
I/O addresses (not memory mapped I/O are limited to 16 bits (A0–
A15). Make sure that bits A16, A17 and A19 are 0 (A18 is a don't
care) to correctly enable the external DREQ0 input.
2. Specify memory to/from I/O or memory to/from memory mapped I/O
mode and address increment/decrement in the SM0, SM1, DM0 and
DM1 bits of DMODE.
3. Load the number of bytes to transfer in BCR0.
4. Specify whether DREQ0 is edge- or level-sense by programming the
DMS0 bit of DCNTL.
5. Enable or disable DMA termination interrupt with the DIE0 bit in
DSTAT.
6. Program DE0: = 1 (with DWEO = 0 in the same access) in DSTAT
and the DMA operation begins under the control of the DREQ0 input.
Memory to ASCI - Channel 0
Channel 0 has extra capability to support DMA transfer to/from the on-
chip two channel ASCI. In this case, the external DREQ0 input is not
used for DMA timing. Rather, the ASCI status bits are used to generate an
internal DREQ0 The TDRE (Transmit Data Register Empty) bit and the
RDRF (Receive Data Register Full) bit are used to generate an internal
UM005001-ZMP0400
ZILOG [ ZILOG, INC. ]
