Three Port 10/100 Managed Ethernet Switch with MII
Datasheet
13.1.2.4
LED Configuration Register (LED_CFG)
Offset:
1BCh
Size:
32 bits
This read/write register configures the GPIO[7:0] pins as LED[7:0] pins and sets their functionality.
BITS
DESCRIPTION
TYPE
DEFAULT
31:10
9:8
RESERVED
RO
-
LED Function 1-0 (LED_FUN[1:0])
These bits control the function associated with each LED pin as shown in
Table 12.1 of Section 12.3, "LED Operation," on page 144.
R/W
Note 13.2
Note:
In order for these assignments to be valid, the particular pin must
be enabled as an LED output pin via the LED_EN[7:0] bits of this
register.
7:0
LED Enable 7-0 (LED_EN[7:0])
This field toggles the functionality of the GPIO[7:0] pins between GPIO and
LED.
R/W
Note 13.3
0: Enables the associated pin as a GPIO signal
1: Enables the associated pin as a LED output
Note 13.2 The default value of this field is determined by the configuration strap LED_fun_strap[1:0].
Configuration strap values are latched on power-on reset or nRST de-assertion. Some
configuration straps can be overridden by values from the EEPROM Loader. Refer to
Section 4.2.4, "Configuration Straps," on page 45 for more information.
Note 13.3 The default value of this field is determined by the configuration strap LED_en_strap[7:0].
Configuration strap values are latched on power-on reset or nRST de-assertion. Some
configuration straps can be overridden by values from the EEPROM Loader. Refer to
Section 4.2.4, "Configuration Straps," on page 45 for more information.
SMSC LAN9313/LAN9313i
159
Revision 1.2 (04-08-08)
DATASHEET
SMSC [ SMSC CORPORATION ]
