欢迎访问ic37.com |
会员登录 免费注册
发布采购

LAN9210 参数 Datasheet PDF下载

LAN9210图片预览
型号: LAN9210
PDF下载: 下载PDF文件 查看货源
内容描述: 外形小巧单芯片以太网控制器与HP Auto-MDIX的 [Small Form Factor Single- Chip Ethernet Controller with HP Auto-MDIX]
分类和应用: 控制器以太网
文件页数/大小: 458 页 / 4618 K
品牌: SMSC [ SMSC CORPORATION ]
 浏览型号LAN9210的Datasheet PDF文件第257页浏览型号LAN9210的Datasheet PDF文件第258页浏览型号LAN9210的Datasheet PDF文件第259页浏览型号LAN9210的Datasheet PDF文件第260页浏览型号LAN9210的Datasheet PDF文件第262页浏览型号LAN9210的Datasheet PDF文件第263页浏览型号LAN9210的Datasheet PDF文件第264页浏览型号LAN9210的Datasheet PDF文件第265页  
High Performance Two Port 10/100 Managed Ethernet Switch with 32-Bit Non-PCI CPU Interface  
Datasheet  
14.2.9.3  
Hardware Configuration Register (HW_CFG)  
Offset:  
074h  
Size:  
32 bits  
This register allows the configuration of various hardware features including TX/RX FIFO sizes, Host  
MAC transmit threshold properties, and software reset. A detailed explanation of the allowable settings  
for FIFO memory allocation can be found in Section 9.7.3, "FIFO Memory Allocation Configuration,"  
on page 121.  
Note: This register can be polled while the LAN9312 is in the reset or not ready state (READY bit is  
cleared).  
BITS  
31:28  
27  
DESCRIPTION  
TYPE  
RO  
DEFAULT  
RESERVED  
-
Device Ready (READY)  
RO  
0b  
When set, this bit indicates that the LAN9312 is ready to be accessed. Upon  
power-up, nRST reset, soft reset, or digital reset, the host processor may  
interrogate this field as an indication that the LAN9312 has stabilized and is  
fully active.  
This bit can cause an interrupt if enabled.  
Note:  
With the exception of the HW_CFG, PMT_CTRL, BYTE_TEST, and  
RESET_CTL registers, read access to any internal resources is  
forbidden while the READY bit is cleared. Writes to any address  
are invalid until this bit is set.  
Note:  
This bit is identical to bit 0 of the Power Management Control  
Register (PMT_CTRL).  
26  
25  
AMDIX_EN Strap State Port 2  
RO  
RO  
RO  
Note 14.47  
Note 14.48  
-
This bit reflects the state of the auto_mdix_strap_2 strap that connects to  
the PHY. The strap value is loaded with the level of the auto_mdix_strap_2  
during reset and can be re-written by the EEPROM Loader. The strap value  
can be overridden by bit 15 and 13 of the Port 2 PHY Special Control/Status  
Indication Register (Section 14.4.2.10).  
AMDIX_EN Strap State Port 1  
This bit reflects the state of the auto_mdix_strap_1 strap that connects to  
the PHY. The strap value is loaded with the level of the auto_mdix_strap_1  
during reset and can be re-written by the EEPROM Loader. The strap value  
can be overridden by bit 15 and 13 of the Port 1 PHY Special Control/Status  
Indication Register (Section 14.4.2.10).  
24:22  
RESERVED  
SMSC LAN9312  
261  
Revision 1.2 (04-08-08)  
DATASHEET  
 复制成功!