GP1A52HRJ00F
Manufacturing Guidelines
■
●
Soldering Method
Flow Soldering:
Soldering should be completed below 260˚C and within 5 s.
Please take care not to let any external force exert on lead pins.
Please don't do soldering with preheating, and please don't do soldering by reflow.
Hand soldering
Hand soldering should be completed within 3 s when the point of solder iron is below 350̊C.
Please solder within one time.
Please don't touch the terminals directly by soldering iron.
Soldered product shall treat at normal temperature.
Other notice
Please test the soldering method in actual condition and make sure the soldering works fine, since the
impact on the junction between the device and PCB varies depending on the cooling and soldering
conditions.
Flux
Some flux, which is used in soldering, may crack the package due to synergistic effect of alcohol in flux and
the rise in temperature by heat in soldering. Therefore, in using flux, please make sure that it does not have
any influence on appearance and reliability of the photointerrupter.
Sheet No.: D3-A03701EN
9
SHARP [ SHARP ELECTRIONIC COMPONENTS ]
