8.5 RSSI Value
0x04 [default 0x20]
Address
Name
Bits
R/W
Description
-
7..6
r/w
Reserved, always set to 00b
Automatic Gain Control Enable (Continuous Mode only):
0 → Disable AGC
AGC_En
5
r/w
1 → Enable AGC
AGC should be left enabled for most applications
0X04
RSSI Gain Mode Selection (Continuous Mode only):
0 → High gain mode
RSSI_G
4
r/w
r/w
1 → Low gain mode
RSSI_val
3..0
4-bit digital value of RSSI level after A/D conversion.
Table 20
8.6 Data Format Control
0x05 [default 0x0F]
Address
Name
Bits
R/W
Description
Insert sender (local device) address in transmit packet (Burst Mode only):
0 → Insert sender address
DevAdd_En
7
r/w
1 → Do not insert sender address
Output received sender address before payload data on receive (Burst Mode only):
0 → Output sender address
DevAdd_pos
DesAdd_ref
6
5
r/w
r/w
1 → Do not output sender address
Destination address reference (Burst Mode only):
0 → Registers 0x09 - 0x0D
0X05
1 → Provided by the host microcontroller before data is written to FIFO
FIFO length (number of payload data bytes, Burst Mode only):
00000 → 1 byte
00001 → 2 bytes
…
FIFO_len
4..0
r/w
11111 → 32 bytes
Payload data bytes = FIFO_len + 1
where 0 ≤ FIFO_len ≤ 31
default is 01111b
Table 21
www.RFM.com E-mail: info@rfm.com
©2009 by RF Monolithics, Inc.
Technical support +1.800.704.6079
Page 24 of 33
TRC104 - 08/13/09
RFM [ RF MONOLITHICS, INC ]
